No car ---again
#16
Race Director
Thread Starter
Dan, that 21 psi was only done for that run in my sig.
And I have all the mods to support that!
I normally run 13psi...and when the rod went through the car was idling...
No need to say sorry..
And I have all the mods to support that!
I normally run 13psi...and when the rod went through the car was idling...
No need to say sorry..
#17
Unaffiliated
Thanks for not getting peeved.. but you KNOW the chrysler service guys have a tape of that call and play it back going "Did you hear THAT??"
#18
Race Director
Thread Starter
No problem...I'd make a copy of that tape too...the irony...!!! I cant see any other reason why the rod would do that unless the bearing was done...at least I found a short block for $300...this was my throwaway car but I'm beginning to like it!
Thank god it didnt happen to the porsche
btw: I found a cheap beater off of a friend..86 RX7, so that will be covered shortly!
Thank god it didnt happen to the porsche
btw: I found a cheap beater off of a friend..86 RX7, so that will be covered shortly!
#19
Originally posted by Mike Markota
Hah Jack! I'd gladly trade your car for my car...ya know help a bud out
Hah Jack! I'd gladly trade your car for my car...ya know help a bud out
Heheh,
Nice offer, but I'm rather attached to my car right now Tomorrow is MY day to drive it Since hitting the deer in the Porsche and putting the Conquest back to daily duties, my wife has been driving it the most to keep mileage down(I drive 90 miles roundtrip a day, to her 15 miles roundtrip), but once a week I get to drive the Quest.
Can't wait to get the Porsche back on the road though.