MM951

Dan, that 21 psi was only done for that run in my sig.

And I have all the mods to support that!

I normally run 13psi...and when the rod went through the car was idling...

No need to say sorry..

944Fest (aka Dan P)

Thanks for not getting peeved.. but you KNOW the chrysler service guys have a tape of that call and play it back going "Did you hear THAT??"

MM951

No problem...I'd make a copy of that tape too...the irony...!!! I cant see any other reason why the rod would do that unless the bearing was done...at least I found a short block for $300...this was my throwaway car but I'm beginning to like it!

Thank god it didnt happen to the porsche

btw: I found a cheap beater off of a friend..86 RX7, so that will be covered shortly!

88BlueTSiQuest

Heheh,

Nice offer, but I'm rather attached to my car right now Tomorrow is MY day to drive it Since hitting the deer in the Porsche and putting the Conquest back to daily duties, my wife has been driving it the most to keep mileage down(I drive 90 miles roundtrip a day, to her 15 miles roundtrip), but once a week I get to drive the Quest.

Can't wait to get the Porsche back on the road though.