new valence installation!
#1
Campeck Rulez
Rennlist Member
Rennlist Member
Thread Starter
new valence installation!
Man.
It looks sweet.
so heres how we did it. We looked in the wheel well for that one hole.
except it's really not all the way in the wheel well at all.
see.
It looks sweet.
so heres how we did it. We looked in the wheel well for that one hole.
except it's really not all the way in the wheel well at all.
see.
Last edited by Campeck; 11-03-2004 at 05:50 PM.
#3
Campeck Rulez
Rennlist Member
Rennlist Member
Thread Starter
then we put the driver side part up to it and temporarily put some bolts (6 mm) and nuts (same) at the exhaust holes.
then we marked the place were the studs were at.
then we marked the place were the studs were at.
Last edited by Campeck; 11-03-2004 at 06:03 PM.
#5
Campeck Rulez
Rennlist Member
Rennlist Member
Thread Starter
now. I know in the post that I admited to having this spoiler tifo said to drill the holes higher than the marks.
but really the studs fit wherever they friekin feel like it.
but really the studs fit wherever they friekin feel like it.
Last edited by Campeck; 11-03-2004 at 05:59 PM.
#7
Campeck Rulez
Rennlist Member
Rennlist Member
Thread Starter
we used silicone to fill up the holes and fill around the bolt.
That stud that had broken off, we were able to get 3 turns on it. so it worked out.
That stud that had broken off, we were able to get 3 turns on it. so it worked out.
Last edited by Campeck; 11-03-2004 at 06:02 PM.
Trending Topics
#8
Campeck Rulez
Rennlist Member
Rennlist Member
Thread Starter
the other piece was a bit harder due to its length. If you're doing this alone. you'll have more problems than we did. we put it up to the car and put in the two bolts near the exhaust and the one in the middle. then we marked the holes.
Last edited by Campeck; 11-03-2004 at 06:05 PM.
#9
Campeck Rulez
Rennlist Member
Rennlist Member
Thread Starter
then we drilled the holes. and you might geusse why there isnt a picture
but it ended up lookin' pretty sweet.
but it ended up lookin' pretty sweet.
Last edited by Campeck; 11-03-2004 at 06:06 PM.
#10
Campeck Rulez
Rennlist Member
Rennlist Member
Thread Starter
and while we were at it. My new Boge shocks went on along with the 16mm rear sway bar due to its absence before.
Last edited by Campeck; 11-03-2004 at 06:24 PM.
#11
Campeck Rulez
Rennlist Member
Rennlist Member
Thread Starter
now tommorow the whole front end will be put together with new oil pressure sending unit, new struts, and bigger sway bar, and rebuilt A-arms.
then the test drive
new hood crest
then the test drive
new hood crest
Last edited by Campeck; 11-03-2004 at 06:15 PM.