dynatech

I've been on the prowl for a 3.2 ltr crank shaft for a least a month now and feel like i have exhausted all my avenues, some details of what i am after is as follows, 9 bolt with a dowel hole on the drive flange, the big ends and mains must be standard size, BIGS, 54.971/ 54.990.......THE MAINS....59.971/ 59.990..this is standard measurments, if anyone could point me in the right direction it would be a huge help, i have tried most of the wreakers i know of but have come to a dead end,

Thanks in advance,
Scott Reynolds

Peter Zimmermann

Try calling Engine Machine Service (EMS) in L.A. - (310) 641-7019. Talk with either Bill or Dick, maybe they have one, or know where to get one. FYI: They know all the std/std measurements, etc... they are the very fine machine shop that I used for years when I still had my shop.
Pete