Header identity
11-12-2002, 10:54 AM
#1
Addict
Lifetime Rennlist
Member
Lifetime Rennlist
Member
Thread Starter
Join Date: Nov 2002
Location: Rock Hill SC
Posts: 48
Likes: 0
Received 0 Likes
on
0 Posts
Header identity
Can anyone out there identify these headers on my 2.2 911t?
I've never seen any of these before and can't find a single picture of them in my ref books or catalogs.
<a href="http://members.rennlist.com/screamin_yellow/911ex1.JPG" target="_blank">http://members.rennlist.com/screamin_yellow/911ex1.JPG</a>
<a href="http://members.rennlist.com/screamin_yellow/911ex2.JPG" target="_blank">http://members.rennlist.com/screamin_yellow/911ex2.JPG</a>
Pass side is okay so far, but the drivers side has a bit of a vent.
Guess I'll see if I can replace, repair, make from scratch a replacement.
Thanks
I've never seen any of these before and can't find a single picture of them in my ref books or catalogs.
<a href="http://members.rennlist.com/screamin_yellow/911ex1.JPG" target="_blank">http://members.rennlist.com/screamin_yellow/911ex1.JPG</a>
<a href="http://members.rennlist.com/screamin_yellow/911ex2.JPG" target="_blank">http://members.rennlist.com/screamin_yellow/911ex2.JPG</a>
Pass side is okay so far, but the drivers side has a bit of a vent.
Guess I'll see if I can replace, repair, make from scratch a replacement.
Thanks
11-15-2002, 10:51 AM
#3
Rennlist Member
J:
I have never seen anything like those before. The exhaust pipe portions look like they were part of a factory set. Maybe these are very early header/heat exchangers.
I would pitch them and find yourself a set of used SSIs. They're stainless steel so you won't have to worry about rust.
I have never seen anything like those before. The exhaust pipe portions look like they were part of a factory set. Maybe these are very early header/heat exchangers.
I would pitch them and find yourself a set of used SSIs. They're stainless steel so you won't have to worry about rust.
