Tom M'Guinn
July 23, 2020
Here's the harness I made. The factory fuel pump harness has a connector under the car. I discovered this is the same connector used on the brake wear sensors, so I attached that to the relay control wires, so that I could connect it all without altering the factory harness. I covered most of it in protective wire sleeves of various types -- mostly just using up what I had. Sheathing is just what I had handy, with dual wall adhesive-lines heat shrink where needed....
More About This Picture
Vehicle
N/A
Location
N/A
Keywords
N/A
Discover More Pictures
See MoreAdvertisement
Be the first to comment on this picture!