Rennlist - Porsche Discussion Forums
0 2017/11/30 07:29:52
0 2017/11/30 07:29:57
0 2017/11/30 07:29:58
0 2017/11/30 07:30:00
0 2017/11/30 07:30:01
0 2017/11/30 07:30:04
0 2017/12/01 19:02:17
0 2017/12/01 19:02:18
0 2017/12/01 19:03:18
0 2017/12/01 19:03:19
0 2017/12/01 19:04:04
0 2017/12/02 09:49:20
0 2017/12/02 09:51:56
0 2017/12/02 09:52:02
0 2017/12/02 09:52:02
0 2017/12/09 20:22:34
0 2017/12/09 20:24:36
0 2017/12/10 08:36:32
0 2017/12/10 16:48:32
0 2017/12/10 16:48:41
0 2017/12/10 16:48:45
0 2017/12/10 16:48:47
0 2017/12/10 16:48:49
0 2017/12/17 17:38:37
0 2017/12/17 17:45:24
0 2017/12/17 19:10:53
0 2017/12/17 19:21:27
0 2017/12/23 11:10:29
0 2017/12/23 19:12:27
0 2017/12/28 17:56:24
0 2018/01/06 19:44:18
0 2018/01/06 19:44:18
0 2018/01/06 19:44:19
0 2018/01/06 19:44:20
0 2018/01/08 07:46:42
0 2018/01/08 07:46:44
Here you can see I have too much material on the end and no way to move it off to one side or the other. Subsequently I will need to cut out the middle and have a seam. Here is where I would have wrapped the outside edge first and then gather the excess material in the opening for the pod.
Here you can see I have too much material on the end and no way to move it off to one side or the other. Subsequently I will need to cut out the middle and have a seam. Here is where I would have wrapped the outside edge first and then gather the excess material in the opening for the pod.
0 2018/01/26 13:57:29
This corner was particularly tricky until I poked with a screwdriver. I will admit the trim job is messy
This corner was particularly tricky until I poked with a screwdriver. I will admit the trim job is messy
0 2018/01/26 13:57:30
0 2018/01/26 13:57:30
you can see some imperfections showing through from the substrate.
you can see some imperfections showing through from the substrate.
0 2018/01/26 13:57:30