GT4 Brake pressure over OBDII
#1
Instructor
Thread Starter
GT4 Brake pressure over OBDII
This topic has been resting for a while, so I thought I would check in to see if anyone knew if AIM had upgraded any firmware to allow brake pressure over OBDII?
Someone say yes, c'mon. Please.
First track weekend coming up with the GT4, coming from a GTS and this is *$#$* frustrating not to have brake pressure. Did I mention the garage is hot in Texas in July?
-Sweating on my keyboard
Someone say yes, c'mon. Please.
First track weekend coming up with the GT4, coming from a GTS and this is *$#$* frustrating not to have brake pressure. Did I mention the garage is hot in Texas in July?
-Sweating on my keyboard
#2
Rennlist
Basic Site Sponsor
Basic Site Sponsor
Join Date: Jun 2008
Location: Durham, NC and Virginia International Raceway
Posts: 19,079
Received 3,237 Likes
on
1,856 Posts
Not yet, AFAIK. Works great on CAN, and it's a simple install.
#4
Rennlist
Basic Site Sponsor
Basic Site Sponsor
Join Date: Jun 2008
Location: Durham, NC and Virginia International Raceway
Posts: 19,079
Received 3,237 Likes
on
1,856 Posts
Power and ground, GT4 and GT3
Add a taps for the CAN connection.CAN add-a-tap connectors
Been making up terminated cables that make it a lot easier and quicker to connect without alteration to the car harness.
Add a taps for the CAN connection.CAN add-a-tap connectors
Been making up terminated cables that make it a lot easier and quicker to connect without alteration to the car harness.
#5
Rennlist Member
I mentioned this in a previous post, but on my Clubsport thru the OBD, I was able to get the brake pressure. Perhaps it was because it is a PDK but I recall other GT4's were able to get a read out as well.
#6
Rennlist
Basic Site Sponsor
Basic Site Sponsor
Join Date: Jun 2008
Location: Durham, NC and Virginia International Raceway
Posts: 19,079
Received 3,237 Likes
on
1,856 Posts
Would love to see that. Do you use the 991_981_OBDII configuration?
I use MoTeC on several ClubSport GT4's, and that has pre and post gateway brake pressure available. But have not connected a Solo DL or other AiM device to the OBDII. PMNA wants it clear in the series.
I use MoTeC on several ClubSport GT4's, and that has pre and post gateway brake pressure available. But have not connected a Solo DL or other AiM device to the OBDII. PMNA wants it clear in the series.
__________________
-Peter Krause
www.peterkrause.net
www.gofasternow.com
"Combining the Art and Science of Driving Fast!"
Specializing in Professional, Private Driver Performance Evaluation and Optimization
Consultation Available Remotely and at VIRginia International Raceway
-Peter Krause
www.peterkrause.net
www.gofasternow.com
"Combining the Art and Science of Driving Fast!"
Specializing in Professional, Private Driver Performance Evaluation and Optimization
Consultation Available Remotely and at VIRginia International Raceway