When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Looking at the catalog it shows an o-ring for the return tube and shows a boss sticking out where it would go. But on my return tube and block both surfaces are flat? Do some return tubes not use o-rings and some do? Not that a leaky return tube would hurt but I want to assemble it with the o-ring if it's supposed to use one or whatever is correct.
Edit - Early 82-85 shows o'ring. Long shot from memory, but if your lower crankcase (early only) requires the o'ring, it will be machined (a step in dia.) to accept it, if late, it will have a slightly raised boss for a rest.
I always cross reference all the catalogs I have. I believe that picture showing it is from at 944_2 89 91 catalog. Where the 85 88 one doesn't show it. Just curious if the o-ring is for a specific return tube or what. Or why it was added? My tube is flat on the bottom with a small notch that lines up with the girdle which is flat with the raised alignment notch. If no o-ring is used, does it go on dry? With loctite 574? Or? Dont see much on the return tube in general.
I bought that seal few days ago from porsche dealer and it was less than $1 delivered next day. My 89 turbo return line has a boss there but not nearly as long as on the drawing.
I bought that seal few days ago from porsche dealer and it was less than $1 delivered next day. My 89 turbo return line has a boss there but not nearly as long as on the drawing.
I find it odd the early engines used an o-ring.... then the 87s didn't.... then the late cars did?. Makes me question not using a o-ring on mine. I would think it would have a thin gasket or something? Definitely don't have a boss for an o-ring to fit..