Peedster

Hi guys,

Bought a new set of coilovers! H&R Clubsport with Nürburgring setting.

Using my old ground control camberplates but the bearing hole in the plates are 16mm whereas the threaded rod from the struts are 14mm.

What to do?

Thanks
​​​​​​​/P

weez58

I go to my lathe and turn a set of adapter bushings....

I assume you would be able to order a set from Ground Control.

Local machine shop?

Peedster

Yes i guess a bushing would be necessary.
And probably need to get custom machined.

Ok then I'll start looking into this.

Thanks
​​​​​​​/P

V2Rocket

http://www.industrialproductsdirect....Fd22wAodrN8NgQ


http://cuttingtoolpickers.com/index....=117&pID=13159

Peedster

Thanks Rocket, thanks to your tip I found a bunch of bearings!

​​​​​​​/P

Peedster

One more Q guys...

I'm thinking if this looks correct? Should it look like this where the top hat meets the camberplate?

Also will the M14 nut go down all the way against the bearing from upp?


When end the nut is torqued the top hat will bind against the camberplates.
Top hat is from H&R coilover. Should there be a GC top hat?










thanks again
​​​​​​​/P