KenRudd

On the final stages of my S3 motor assembly, and I cannot figure out where this goes. I had it in the bag with my spark plug wiring brackets, and it has been powered coated, but I cannot figure out where it went:







it is NOT 928.602.051.02 (26) or 9218.602.051.00 (29) from PET below, I have those accounted for.

SeanR

Mounts to the rear of the passenger side head and the wiring harness is clamped to it.

KenRudd

Thank you!

I poured all over my pre-tear down pictures and on every drawing in PET and could not find it.

Rob Edwards

Typical Porsche, different shape for that bracket between S3 and S4.

BC

There are three-ish that are similar. One The S3 setup has two at the front of the motor as I recall. One is noticeably longer.

bogdann

Bracket 29 attaches to the water bridge

This is on my Aust delivered car. I think you have bracket 29 in the picture? That is attached to the water bridge on my car and bracket 26, pictured below attaches to the fan bracket.




Bracket 26 attaches to fan bracket

KenRudd

Here it is mounted in the correct place:


It did very much look like one of the front brackets for holding spark plugs wires, which threw me off.

Randy V

That engine is gonna look pretty sharp black with red highlights.

KenRudd