Fracture

so I bought an aftermarket lip/spoiler off eBay as the OEM has seen better
days

http://www.ebay.com/itm/Porsche-996-.../150751922965?




so today was bumper service, clean out the rads and stuff
install some mesh behind the intakes

should fit right, looks a little short by about 5/8' or so
tried bending the bumper (it's off the car)

any tricks ?

thanks in advance

jj1

That's a lip, not a splitter. I don't have any tricks for you but in general the eBay stuff isn't known for quality fitment.

5CHN3LL

Make sure you have it dead center, and then start from the middle and work outward. Mock it up with blue painter's tape if necessary...

Viper6

Watching with interest, mine needs replacing and prefer non-Oem for this part if possible... let us know if you cracked the install and if you would recommend.

Fracture

working on it....

and success




5CHN3LL's approach worked
secure top of bumper, measure for center and work to ends
you have to dispense with a couple of clips on end at wheel well
and don't be afraid to add a couple of TEK's around the inlets to stiffen it

luckily, I already had primer and 1 coat finish already on, so I just
shot another couple of coats

cleaned radiators