Bumperette Delete Inserts. Who's in?
#122
Rennlist Member
Thread Starter
Whether I will be doing this again depends on demand. I have to order runs of 20 sets. If there are still 20 people who want these, raise your hand and I will start a list. The problem is that I don't want to take money from anybody until I'm ready to order BUT people who expressed interested evaporated when it came time to order. In the end about 50% of the people who expressed interest actually ordered a set. I could limit it to 20 units and say the first 20 people to send $117 will get a set? I just don't know what's best.
I actually have 3 sets spare if anybody wanted a set immediately. There were 46 orders and I had to round it up to 50 minus one for me
G
I actually have 3 sets spare if anybody wanted a set immediately. There were 46 orders and I had to round it up to 50 minus one for me
G
#125
Rennlist Member
#126
Rennlist Member
Got mine yesterday, did some minor trimming and they fit great, I ended up removing one of the three stepped sides that are towards the center of the car, I was happy to have the choice on which side to remove for best fit on my car. Thank you for all of your efforts on this project. I will post pics once they're all painted up.
#127
Rennlist Member
Thread Starter
Got mine yesterday, did some minor trimming and they fit great, I ended up removing one of the three stepped sides that are towards the center of the car, I was happy to have the choice on which side to remove for best fit on my car. Thank you for all of your efforts on this project. I will post pics once they're all painted up.
G
#129
Rennlist Member
Yup, snapped the driver's side plug in last night while finishing up the new fog light harness. Didn't even sand down an edge, just tilted and snapped it in. Very snug fit, and might be a bit challenging to remove when the paint arrives. Nice job Gavin!
#130
Rennlist Member
Thread Starter
G
#131
Rennlist Member
I received my set a few days ago and I am very happy with my set! Great work gmorat--you da bomb! Now to figure out my fit, sanding, and prime/paint strategy.
Magicscott
Magicscott
#135
Rennlist Member
Thread Starter