crushingday

I have an unused pair of what I believe to be 944t rear Zimmerman cross drilled rotors. The hat is a bit cone shaped and I was wondering if these are the standard 944T rear rotors or if this sloping of the hat is to fit bigger brakes? I need to know what thay are to sell them and a few other parts.

These were purchased a decade or more ago and I have since sold my '87 944/968

The cross drilling pattern seems a bit different than the drilling I see now and the holes are beveled a bit?

Voith

Rear rotors, should fit on any 944 as far as I know.

There is another brake surface on the inside for handbrake shoes.

I might be interested in these if the price is right

crushingday

Voith. I am not sure what the average going rate for these is. Whatever that is I would go lower.

lart951

those look like 86 turbo rear rotors wont fit 87

crushingday

Not sure about that. I know I ordered them for my '87. But thanks you for the post. I will look into it more and see what others have to say.

lart951

I say they early and that's what they are that's what I do for living 944 Turbo parts.

1st pict are 87 951 and up front rotors non M030
2nd pict are 87 951 and up rear rotors will fit M030
3rd pict are 86 951 front rotors
4th pict are 86 951 rear rotors

crushingday

Well, I guess i was misinformed when I got them for my '87.
Thanks for clarifying.

Voith

Thanks lart. I need M030 rears..

mel_t_vin

For a 951...no such thing.

Late offset rear rotors are the same part, whether chassis is M030-optioned or not.

Voith

968 CS m030 OE rear rotors should fit on late offset m030 951, no?

These:




I will use 993TT front rotors and think these would fit togeter nicely.

mel_t_vin

As far as I know, the only difference between 968 M030 and non-M030 rear rotors is the cast holes. I don't believe there are any dimensional differences [diameter, thickness]. No difference between rear calipers/pads. In addition, not all Club Sports were configured with the M030 option.

To answer your question...yes, the 968 M030 rear rotors [$$$] should fit any late offset 951.

And I agree...they will look very nice paired with 993 turbo rotors/calipers.

Jason @ Paragon Products

If you need a drilled rear rotor for the 87-89 Turbo, the Zimmerman drilled version of 951.352.041.02 will be much more affordable than the 968 M030 version.

lart951

Voith, make sure that you order some M030 brake fluid to match the rear M030 rotors.

Scott at Team Harco

What if I have M030 rotors in the rear and standard rotors in the front? Is it OK to mix the M030 brake fluid, with say, ATE blue?

Voith

I have one can of m030 fluid for front, will trade half of it for rear 030 fluid. Lart?