Bosch alternator pulley tool
#1
Rennlist Member
Thread Starter
Bosch alternator pulley tool
I have a decoupler pulley that I need to install. This requires a special tool. Andrew lent me his but the 4 square bit that goes through the centre was too small. It takes a 10mm. I have a 10mm 12 point but the shaft is too big to fit through the outer piece. Does anyone have this tool that I can use for 20 minutes?
#4
Drifting
James,
Andrew told me the ID of his tool was .500 , i took a vernier and measured my bit,although
it's hexagonal , the OD is .445
Just might work for you ...
Let me know !
Andrew told me the ID of his tool was .500 , i took a vernier and measured my bit,although
it's hexagonal , the OD is .445
Just might work for you ...
Let me know !
#7
Drifting
Yes James ... 10 mm
And as far as Calabogie goes , i was exposing my bit to somebody else upstairs while you yahoos
were watching Borat at full volume !
So , there ...
And as far as Calabogie goes , i was exposing my bit to somebody else upstairs while you yahoos
were watching Borat at full volume !
So , there ...
Trending Topics
#8
Rennlist Member
Not to digress too far here, was in Chicago for the weekend and loved this - Weiner Circle is an 'experience', but this is just funny.
Great town BTW.
http://www.chicagotribune.com/redeye...309-story.html
Great town BTW.
http://www.chicagotribune.com/redeye...309-story.html