HOUSTON AREA - Kind of Urgent Need for Right Rear Rotor - 996 GT3
#1
Rennlist Member
Thread Starter
HOUSTON AREA - Kind of Urgent Need for Right Rear Rotor - 996 GT3
X-post from GT3 forum.
Anyone in the Houston area have an extra right rear rotor lying around? I'll replace it when Suncoast sends the replacement. 996.352.406.01.
I ordered a set of rear rotors from Suncoast and unfortunately, they sent two left rotors. I'm not worried about getting the right one from them, but I kind of need one for this weekend - and there isn't enough time to get one from Florida. My rear rotors can probably take one more event, but I already replaced the front rotors and switched pads from Pagid to PFC-06. If I can't get a rotor ASAP, I am probably going to run PFC-06 in the front and RS-14 in the rear this weekend. Probably not optimal, but I don't want to bed a new set of PFC-06s on almost dead rotors.
Thanks,
-td
Anyone in the Houston area have an extra right rear rotor lying around? I'll replace it when Suncoast sends the replacement. 996.352.406.01.
I ordered a set of rear rotors from Suncoast and unfortunately, they sent two left rotors. I'm not worried about getting the right one from them, but I kind of need one for this weekend - and there isn't enough time to get one from Florida. My rear rotors can probably take one more event, but I already replaced the front rotors and switched pads from Pagid to PFC-06. If I can't get a rotor ASAP, I am probably going to run PFC-06 in the front and RS-14 in the rear this weekend. Probably not optimal, but I don't want to bed a new set of PFC-06s on almost dead rotors.
Thanks,
-td
#2
Rennlist Member
Thought you were in DFW? I've got a set in my garage at MSR-Cresson. Pretty sure you are running the same size as I have on my 996 as mine were upgraded to the same size as the Cups. Shoot me a note if I can help you.
I just checked my notes, they are 330mm in diameter, Porsche factory part. Don't have the part number handy.
I just checked my notes, they are 330mm in diameter, Porsche factory part. Don't have the part number handy.
#3
Rennlist Member
Thread Starter
Thought you were in DFW? I've got a set in my garage at MSR-Cresson. Pretty sure you are running the same size as I have on my 996 as mine were upgraded to the same size as the Cups. Shoot me a note if I can help you.
I just checked my notes, they are 330mm in diameter, Porsche factory part. Don't have the part number handy.
I just checked my notes, they are 330mm in diameter, Porsche factory part. Don't have the part number handy.
I wish I would have checked before tonight, as my wheels are en route from PST to MSR-H.
Thanks for the offer!
-td