Jarez Mifkin

The ball/socket that controls the thottle vavles on the left bank popped loose this past weekend. I don't have a good picture of it, but it is the same as the ones located behind the 'squirrel cage' in the picture below. Anyone know where I can get some of these?
Thanks!

JoeMag

that looks like the same one that's used on throttle pedal linkage. ...hard to tell if size is the same.

Jarez Mifkin

Yeah, that's what I was thinking to after looking at the parts diagrams. On the street cars there is only one linkage, where I have one linkage per side.

mklaskin

Joe,

That's basically what my intake looks like. The only differences are that the mesh is wrapped differently and is mounted towards the inside of the engine compartment. Kelly Moss also honed out the inside for a little more air volume.

I'm still kicking around ITB's. I may switch to ITB's and slide valve for Daytona. We'll see...

AndyT

Check with Joel Reiser.

JoeMag

Mike -- Doesn't your car have ITB's? Thought the RSR had ITB's with that big intake sitting on top of them.

mklaskin

Joe,

With that intake on top of ITB's, I'd never get my decklid shut...

Seriously, that's almost identical to what I have. When my motor's finished, I'll take a bunch of photos and send them to you.