FS: 996 GT3R (127 mm) Pankl Rods
#1
Burning Brakes
Thread Starter
FS: 996 GT3R (127 mm) Pankl Rods
I have a set of early GT3R/Cup 127.x mm pankl Ti rods. These rods were reconditioned 20 hours ago (I believe they have <60 hours total time), but were in an engine that had a thrust bearing failure. 2 of the rods have some wear on the faces due to the end play when the thrust bearing went. They were a bit out of spec in terms of side clearance so I replaced them when we rebuilt the engine.
These are the rods to have for a hot-rod air cooled motor. Don't think these are available from Porsche anymore and similar aftermarket Ti pieces go for about $1200 a rod.
$1500 obo for the set of 6.
email me at claykos AT gmail.com if you're interested.
These are the rods to have for a hot-rod air cooled motor. Don't think these are available from Porsche anymore and similar aftermarket Ti pieces go for about $1200 a rod.
$1500 obo for the set of 6.
email me at claykos AT gmail.com if you're interested.