H2Ocooledesteem

I would like to see Porsches PET diagrams of them and actual clean photos of them on a 996 chassis. It would also be helpful to indicate the O/D of the front and rear bar and a possible explanation as to why the 996 blades aren't splined like the 99 ones are.

Thank you for any help and clarification in the matter.

rbahr

I think they started this on the 997 cup cars, the 996 cup had the same type as on the street car, sorry no real picture

Cemoto

.
Subscribed - I'm looking for a pair of 996 RSR (shown here) blades if anyone has them hanging around please shoot me a PM. 996.333.725.9

The bladed rear bar installed on my 996 cup is a non-factory adjustable hollow 35mm one but it uses the factory RSR blades. Not sure I have a clean photo or if I did, it would help you.

These PET images are from a 2002RS.

Thank you . . .





.

H2Ocooledesteem

I forgot they offered a single and dual bladed setup. I am after the dual bladed bars. I looked high and low for those blades as they differ tremendously from the 997 in size and the fact that the 997 ones are splined. Which is a little confusing to me on how the adjustability works on the smooth 996 ones.
Cemoto,
does the rear bar have a larger O/D than the front?

Cemoto

.

Both bars in the attached diagrams have the same diameter listed as 30mm (part #1 and part#8), mine are not the same diameter. sending you a PM.

Al

H2Ocooledesteem

Here’s the bars I have

Cemoto

.

What size (thickness) are those?

.