2010 4S - Unable to start, stuck in HOLD Mode
#1
![Question](https://rennlist.com/forums/images/icons/icon5.gif)
My current situation is that my 2010 4S will not start. I am troubleshooting the Start Relay/Fuses, but I am preparing to dig in to replace the Starter (and other things while I am in there).
When I had the car towed to my house, it is sitting on my slightly inclined driveway. I went out yesterday with my son to push it into my garage, but since it is on an Incline, the HOLD feature seems to be in place.
Since I cannot start the vehicle (there is power though), I am not able to disengage this as you normally would when pressing the Accelerator.
I cannot find a way to disengage this through a setting at the moment.
I wanted to see if any of you have been through this scenario before and had some suggestions that I can try.
Thank you
When I had the car towed to my house, it is sitting on my slightly inclined driveway. I went out yesterday with my son to push it into my garage, but since it is on an Incline, the HOLD feature seems to be in place.
Since I cannot start the vehicle (there is power though), I am not able to disengage this as you normally would when pressing the Accelerator.
I cannot find a way to disengage this through a setting at the moment.
I wanted to see if any of you have been through this scenario before and had some suggestions that I can try.
Thank you
The following users liked this post:
justabout (05-08-2023)
#3