993 steering rack DIY rebuild tutorial
#16
Instructor
I didn't had a hard time to take the threaded cap off, but damn it was a hell to put it back!!
And yes, I did put a lot of grease on the pinion/gear and oil everywhere else...
Thiking more about it, I remember now that the rack has started to be hard to move by hand when I reassemble the pinion shaft (so before adding the pre load)... Need to check that...
But today I'm not sure I feel brave enough to go back under the car to take off the rack, quite a small place actually !!!!
And yes, I did put a lot of grease on the pinion/gear and oil everywhere else...
Thiking more about it, I remember now that the rack has started to be hard to move by hand when I reassemble the pinion shaft (so before adding the pre load)... Need to check that...
But today I'm not sure I feel brave enough to go back under the car to take off the rack, quite a small place actually !!!!
#17
Intermediate
Thread Starter
Join Date: Oct 2009
Location: Berkeley, CA, and Nelson, NZ
Posts: 46
Likes: 0
Received 4 Likes
on
2 Posts
uploaded images again
sorry for the image links missing. I moved host , forgot to re upload them...
email me bcaway@yahoo.com if you need any help I will do my best.
RE: Elonash tight rack issue, I would definitely remove the pinion, and check everything, once reassembled you should be able to turn it by hand and check the backlash feel too.
email me bcaway@yahoo.com if you need any help I will do my best.
RE: Elonash tight rack issue, I would definitely remove the pinion, and check everything, once reassembled you should be able to turn it by hand and check the backlash feel too.