Motec CDL3 in a 986
#1
Racer
Thread Starter
Motec CDL3 in a 986
I have recently installed a Motec CDL3 in my SPB. I am slowing learning all it can do and have successfully tapped into the canbus data. SO I know have RPM, Throttle, Engine Temp and one wheel speed sensor from Canbus. There are a number of GP channels that I am trying to solve what they are. There are 3 that are mapped to something and the correlate to the throttle position two of them are very close to each other and on slightly different. then there is a 4th channel that has math done but I have no idea what it correlates to any thoughts what these channels might be?
#2
Rennlist
Basic Site Sponsor
Basic Site Sponsor
Join Date: Jun 2008
Location: Durham, NC and Virginia International Raceway
Posts: 19,115
Received 3,299 Likes
on
1,874 Posts
Send me an ld file
__________________
-Peter Krause
www.peterkrause.net
www.gofasternow.com
"Combining the Art and Science of Driving Fast!"
Specializing in Professional, Private Driver Performance Evaluation and Optimization
Consultation Available Remotely and at VIRginia International Raceway
-Peter Krause
www.peterkrause.net
www.gofasternow.com
"Combining the Art and Science of Driving Fast!"
Specializing in Professional, Private Driver Performance Evaluation and Optimization
Consultation Available Remotely and at VIRginia International Raceway
#3
Rennlist
Basic Site Sponsor
Basic Site Sponsor
Join Date: Jun 2008
Location: Durham, NC and Virginia International Raceway
Posts: 19,115
Received 3,299 Likes
on
1,874 Posts
Manifold air pressure.
#5
Nordschleife Master
The two that are close are throttle position and pedal position. Throttle typically goes like 0 to ~98%. Pedal should go to 100%.