955/957 Cayenne DIY: Front Rotors and Pads
#61
Will the Brake Pad Workshop light cause the check engine light to come on?
Or is this just a coincidence?
It did go out after driving the car for a few miles.
If it comes back on I will take it into Porsche and have them run the diagnostic codes.
Thanks
SUZU
Or is this just a coincidence?
It did go out after driving the car for a few miles.
If it comes back on I will take it into Porsche and have them run the diagnostic codes.
Thanks
SUZU
#63
Drifting
Thread Starter
#64
to all, great info for the first time DIYer. i just finished the front and am starting on the rear but I have to wait until tomorrow for the triple square tools. still not sure on sizes. m16, m6, m15, t47 or t50. a bit confusing. maybe ill get them all.
the only problem w the step by step directions with pics is that at one point it says to put brake grease on pads and later on it says caution, don't put brake grease on back of pads.
i left the grease off. hope i don't get brake noise.
the only problem w the step by step directions with pics is that at one point it says to put brake grease on pads and later on it says caution, don't put brake grease on back of pads.
i left the grease off. hope i don't get brake noise.
#65
Drifting
Thread Starter
to all, great info for the first time DIYer. i just finished the front and am starting on the rear but I have to wait until tomorrow for the triple square tools. still not sure on sizes. m16, m6, m15, t47 or t50. a bit confusing. maybe ill get them all.
the only problem w the step by step directions with pics is that at one point it says to put brake grease on pads and later on it says caution, don't put brake grease on back of pads.
i left the grease off. hope i don't get brake noise.
the only problem w the step by step directions with pics is that at one point it says to put brake grease on pads and later on it says caution, don't put brake grease on back of pads.
i left the grease off. hope i don't get brake noise.
No grease needed.
#66
Burning Brakes
I almost improperly bought 350mm fronts and 330 rears....
Here are the caliper colors/rotor sizes for fronts
V6/Black Caliper:330mm
V8/Silver Caliper:350mm
V8TT/Red Caliper:350mm
V8TTS/BIG Red Caliper:380mm
Med tech I am going to AutohauzAZ, great cost on rotors!!!
Anything above 50 bucks is shipped for free.
Last edited by cordsig79; 03-04-2011 at 12:01 PM.
#67
Rennlist Member
Join Date: Aug 2003
Location: Philadelphia
Posts: 467
Likes: 0
Received 0 Likes
on
0 Posts
I can not comment on the Zimmermann being OE -- but they do not list it as such - and they are normally accurate. I get a lot of stuff from them
The Zimmerman stuff is normally very good.
I bought the whole kit from Sunset -- and the rear rotors I think are $91.00. So it is a little more with shipping. I have had such good luck with the OE stuff that I would rather not play around.
Please report back about the parts -- it would be great information for the future.
I know that Brembo is now making some stuff in China
The Zimmerman stuff is normally very good.
I bought the whole kit from Sunset -- and the rear rotors I think are $91.00. So it is a little more with shipping. I have had such good luck with the OE stuff that I would rather not play around.
Please report back about the parts -- it would be great information for the future.
I know that Brembo is now making some stuff in China
#68
Moderator !x4
I just ordered, Zimmerman Front Drilled/Slotted, Hawk HPS for Front and Rear and Sensors
The Rotors were $241.59 shipped
Front Pads $110
Rear Pads $70
All 4 sensors $40
The Rotors were $241.59 shipped
Front Pads $110
Rear Pads $70
All 4 sensors $40
#71
thanks for the info, I have to find out who's the manufacturer as the OEMs from the dealer are going this side of the pond for about $1020 a piece (ouch...)
#72
Burning Brakes
rear rotors 163.30
rear pads 87.68
rear sensors 23.62
rear hardware kit 25.30 from suncoast
274.60 with free shipping..........plus 25.30...for hardware and maybe some shipping.
Heres the front rotors and pads with sensors
front rotors 186.14
front pads OEM 129.49
front sensors 25.10
front hardware 34.95 from suncoast.
Mike, did you get 4 rotors or just front rotors, if you got 4 slotted, ping me your source for rotors please.....
#73
Rennlist Member
Join Date: Aug 2003
Location: Philadelphia
Posts: 467
Likes: 0
Received 0 Likes
on
0 Posts
Sunset:
charges for the rear
104.67 for the pads
13.98 for each sensor
21.31 for the kit
I also get the two bolts for $1.82 each
Is $240 for all 4 rotors? Great Price.
charges for the rear
104.67 for the pads
13.98 for each sensor
21.31 for the kit
I also get the two bolts for $1.82 each
Is $240 for all 4 rotors? Great Price.