CDC Removal
#2
Pepper Bartender
Rennlist Member
Rennlist Member
#3
theres 3 screws on each side of the changer
if you remove the 10s that hold the changer bracket
you can get the chnager out through the hole
but you need to yank the trim to put it back in
if you remove the 10s that hold the changer bracket
you can get the chnager out through the hole
but you need to yank the trim to put it back in
#4
Pepper Bartender
Rennlist Member
Rennlist Member
not to differ.. but I've been in there working on a beta project and it looks dang difficult to take out.. the bracket appeared to be only take-out-able (is that a word?!) if you pulled the entire rt. rear panel (not just the access panel).. as a result I had to figure out an alternate location for my "project".
#6
#7
Pepper Bartender
Rennlist Member
Rennlist Member
JOhn-boy... welcome back to Pepper-ville.. the sequel! I'm under a top secret confidentiality agreement... but you and sigs are close... think islamo anti-terror dirty sniffer! the new Thule roof rack has the 50's hidden!
Trending Topics
#8
not to differ.. but I've been in there working on a beta project and it looks dang difficult to take out.. the bracket appeared to be only take-out-able (is that a word?!) if you pulled the entire rt. rear panel (not just the access panel).. as a result I had to figure out an alternate location for my "project".
then you pull the changer t
then the bracket
instalation is almost impossible and you have to pull the trim
#10
Addict
Rennlist Member
Rennlist Member
Join Date: Jan 2004
Location: Bethesda, Maryland
Posts: 2,856
Likes: 0
Received 0 Likes
on
0 Posts
#11
Moderator !x4
Thread Starter
OK its out, there is more info required, I will post later, here are the parts I had to remove to get it out and a view and the BOSE amp with the CDC already removed from underneath it.
#13
Super Moderator
Needs More Cowbell
Lifetime Rennlist
Member
Needs More Cowbell
Lifetime Rennlist
Member
Oh wait, what else do I see in that picture, below the amplifier.....no, it can't be.....it's only claimed to have been previously sighted and photographed in court documents.......could it be.......yes, I think it is........
The infamous 1D6 towbar control unit !!!!!!!!!!!!!!!!!!!!!!! Run away, Run away.......
And with that, I finally reach a personal milestone in Rennlist history.....my 10,000th post.
How poetic that # 10,000 would be related to a Bose amplfier and a 1D6 factory towbar control unit module......almost like it couldn't have happened any other way....
10,000....how time flies, how I miss Larry (R.I.P. ).....I wish he were here for this.
#15
3rd Gear
Join Date: Aug 2011
Location: Chestermere, Alberta
Posts: 3
Likes: 0
Received 0 Likes
on
0 Posts
mudman,
In the pic with the amp installed inside the rear panel, there is a cable laying on top of the amp (the one where you can see the a small amount of purple wire at the end). What is this supposed to be connected to? I have all the cables connected into my amp that I can and I have this same cable left over, but not sure where it goes!
thanks
In the pic with the amp installed inside the rear panel, there is a cable laying on top of the amp (the one where you can see the a small amount of purple wire at the end). What is this supposed to be connected to? I have all the cables connected into my amp that I can and I have this same cable left over, but not sure where it goes!
thanks