audipwr1

Anyone try using the SIR bearing tool to remove the centerlock hubs? Can you use it?

surlynkid

I did but not on the car as they suggest leaving the knuckles on the car. I used their pieces and my 20 ton press for some steps and a socket wrench for other steps. It just depended on whether I could get it set up on the press or not.

audipwr1

So you pulled the uprights off the car and then swapped it over off the car?

Ugh I hate pulling uprights

neurotic

which RS did you end up buying? and congrats

audipwr1

White gold - wasn't marketed

Awesome car full maint history - loving it

neurotic

are we going to share pics??! don't be greedy

white/gold that is damn sexy. congrats!

surlynkid

Yes. Two friends tried doing it on the car and each cracked an upright. I forget if it was back or front but a $1700 uh oh.

audipwr1

Ouch ok - guess I'll pull them off - huge time hassle

ngng

i think i paid 1500 for each of my fronts a while back. i've replaced the rear kunckles as well because one of them cracked on track.