CUP splitter needed
#18
Rennlist Member
Thread Starter
Join Date: Nov 2005
Location: Montreal, Canada
Posts: 3,854
Likes: 0
Received 0 Likes
on
0 Posts
Well I called Bill Dougherty and he didn't have the price on hand and he never called back. Sunset gave me a price of 212...... Dell, I guess the prices have gone up. If still have a deal at 150$, please let me know.
#22
Nordschleife Master
IIRC, Sunset can't sell PMNA parts. That price of 212 is for the stock one I believe.
#23
Hey guys, I'm looking for a CUP splitter. I know some of you bought a couple so I'm wondering if any of you are willing to sell. Sunset is out and it could take a while. Prices also seem to have gone up.
Thanks in advance.
BTW still looking for a set of metropol blue euro GT3 seats.
Thanks in advance.
BTW still looking for a set of metropol blue euro GT3 seats.
#24
Rennlist Member
Thread Starter
Join Date: Nov 2005
Location: Montreal, Canada
Posts: 3,854
Likes: 0
Received 0 Likes
on
0 Posts
Thanks guys but I found one. Now just need to order a new one to give to Mike K. Still waiting answers from Bill Dougherty and Scott from TRG.
#25
Three Wheelin'
A while ago I purchased 2 cup splitters and kept one as a backup. Well, it was stored hanging in my garage on a nail for over a year. I looked at it and the front center section of about 6 inches was slightly bent/distorted so it did not seat properly. Basically a few of the push pins do not go all the way in. I am not confident it will stay on at speed.
The moral of the story is make sure to properly store your backup -- lesson learned.
Time for a little tape to help patch the gap in the front.
The moral of the story is make sure to properly store your backup -- lesson learned.
Time for a little tape to help patch the gap in the front.
#26
Rennlist Member
Join Date: Sep 2006
Location: Vancouver, BC, Canada
Posts: 1,968
Likes: 0
Received 0 Likes
on
0 Posts
You should use 1/2" wide double-sided tape around the outside perimeter in any case. Helps keep it from flying off at speed. Just last week a fellow lost his splitter at Pacific Raceways because he didn't have that tape on.
To help flatten a bent splitter you can clamp a couple pieces of wood on both sides to flatten it. Do this for a few days before putting it on.
In my case I autox my car as well and smacking a cone separated the mounting tape. Rather than remove the splitter, clean it up and remount it, I just used some black duct tape to cover the gaps so air couldn't get in there and rip off the splitter. Worked fine at Portland and Seattle last week.
Cheers,
To help flatten a bent splitter you can clamp a couple pieces of wood on both sides to flatten it. Do this for a few days before putting it on.
In my case I autox my car as well and smacking a cone separated the mounting tape. Rather than remove the splitter, clean it up and remount it, I just used some black duct tape to cover the gaps so air couldn't get in there and rip off the splitter. Worked fine at Portland and Seattle last week.
Cheers,
#27
Rennlist Member
EDIT
I talked to bill, he is still waiting on Porsche Motorsports...hell get back soon.
Last edited by sechsgang; 08-05-2008 at 06:28 PM.