NJ-GT

Dale Gribble

nice install.


i don't suppose you could tell me how to cut the carpet so that it fits around harness bars ?
does the factory have a separate piece of carpet for ppl with the tequipment bar?

and most importently: how much are those motons and where can i get em in canada

sharkster

If you have a GT3 Tequipment roll bar we have mounts that EVO made that work well- just make sure you have the quick disonnects and enough length in the line for the rear (seems like you do). That way it's much easier to adjust them.

And a front strut brace you can do what we do here:

Z06

NJ-GT,
thanks for the pictures

gtdrei

Here's how we did mine:
The Harness bar is a B-K, and only required 2 small slits in the carpet near the rear strut tops, which also make it easier to get at the rebound adjustment.







Robin

GT3 Nut

I have the SWEETEST set up for the front canisters. I will post pictures ASAP. Nothing I have seen compares!

Ed Newman

Where did you get the brackets for the rear bar and do they make ones to fit the Porsche cubsport cage?

mooty

yes, robin, i want the bracket you got for those canisters.

gtdrei

They were made by a machine shop here in town. (Seattle area) I believe they have built them for the Clubsport cage, as there are some guys here with that setup. I'll check, and put you guys directly in touich with the source. PM me with your e-mail addresses.

Robin

NJ-GT

They fit the Clubsport cage. I've a set I never used, because my car doesn't have a rollbar.

gtdrei

Ed, Mooty,
I sent you both PM's.

Robin