2002 Leg Room
02-14-2008, 02:32 PM
#2
Newbies Hospitality Director
Lifetime Rennlist
Member
Lifetime Rennlist
Member
Join Date: Apr 2005
Location: Winston-Salem, NC
Posts: 18,084
Likes: 0
Received 34 Likes
on
33 Posts
I am 6'3" with a 34" inseam and can't put the seat all the way back because I wouldn't be able to push the clutch all the way to the floor.
I guess you could to attempt to move the rails further back.
I guess you could to attempt to move the rails further back.
02-14-2008, 03:17 PM
#4
Addict
Rennlist Member
Rennlist Member
Look at the rear mounting area of the floor, and see if there is an extra set of mounting holes about 1/2 inch back. The older models had them, and they were covered in black paper tape. Removal of the seat is not required to check this out, just slide it all the way forward.
Steve
Steve
02-14-2008, 03:23 PM
#5
Nordschleife Master
Look at the rear mounting area of the floor, and see if there is an extra set of mounting holes about 1/2 inch back. The older models had them, and they were covered in black paper tape. Removal of the seat is not required to check this out, just slide it all the way forward.
Steve
Steve
The newer cars do not have these.
C.
02-14-2008, 04:02 PM
#6
Advanced
Join Date: Jan 2008
Location: RIVERSIDE, CA
Posts: 63
Likes: 0
Received 0 Likes
on
0 Posts
Question for Chad!
Apologies, but this is nothing to do with the original post!! 
Hey Chad,
Are those Sport Design's on your 996? Did you have them powder coated or painted Black?? I'm looking to get a set for my Blk on Blk 996!! Where did you purchase them from?
Cheers,
Karl.
Hey Chad,
Are those Sport Design's on your 996? Did you have them powder coated or painted Black?? I'm looking to get a set for my Blk on Blk 996!! Where did you purchase them from?
Cheers,
Karl.
02-14-2008, 05:44 PM
#7
Nordschleife Master
They are factory GT3 wheels I bought used from another P-car owner. I got them powder coated (see your thread).
C.