Eharrison

I just received the B&M SSK and EVO shift linkage, everything is going well up to the point where I am trying to get the EVO linkage onto the B&M shift ****. How much hammer is needed to get the thing on? I'm afraid I'm going to break something....I'm searching the forum for an answer until someone can clue me in. Thanks.

Tool Pants

I hit it with a dead blow plastic covered mallet and then it snapped on. Owner was holding the shift tower on it's side when I gave it the wack.

Eharrison

Thanks, I went out there and placed on a table upside down and gave it some good smacks witha five pound sledge, nothing near smacking it with someone holding it. It's not damaged and popped right in, when I hit it light, you could feel it slide on but then pop off. Shifts really nice. I only had a chance to drive it for ten minutes but i know I'm going to enjoy it.