Notices
996 Forum 1999-2005
Sponsored by:

Clear Armor question, help....

Thread Tools
 
Search this Thread
 
Old 08-02-2005, 02:41 AM
  #1  
c4bliss
Racer
Thread Starter
 
c4bliss's Avatar
 
Join Date: Jan 2005
Posts: 395
Likes: 0
Received 0 Likes on 0 Posts
Default Clear Armor question, help....

Ok, question: I have clear armor on my car. It was just applied. The old was removed due to a very poor install, many fingerprints and stretch marks ect.

So i just get my car back tonight. While looking it over in my garage, i notice many many scratches and ect, from what appears to be the removal of the old armor. The new armor was installed on top of the scratches so i cant get to them to rub them out.

Also, while looking at the front bumper, it appears that they split the armor horizontally across the bumber right below the bumper plugs, from fender to fender. Isn't this supposed to be a one piece install? Not split? It looks like they cut the old with a razor and and matched the new on to it. Is this normal? I am gonna reserve calling up the installer until i get it washed and see what it looks like.

Last edited by c4bliss; 08-02-2005 at 11:58 AM.
Old 08-02-2005, 12:22 PM
  #2  
LVDell
Nordschleife Master
 
LVDell's Avatar
 
Join Date: Oct 2003
Location: Tobacco Road, NC
Posts: 5,225
Likes: 0
Received 28 Likes on 23 Posts
Default

Sounds like your new installers are just a worthless as the first installers. These are questions you should have covered up front with them. Did you? If so, then they need to either 1)refund your $$$ or 2)redo it.

I made sure that my installer was top notch (does all the Porsche dealer cars here under "contract" and even CGT's!). I checked past work, asked around, etc.

In addition, I watched pretty much the entire install so I could alert them of any conflicts between what they were doing and what I wanted. Also wanted to see exacatly how much work goes into a proper install. These guys spent rougly 8 hours on my car!

I have ZERO seams on my entire front GT3 bumper because they did a custom 1-piece install.
Old 08-02-2005, 12:38 PM
  #3  
c4bliss
Racer
Thread Starter
 
c4bliss's Avatar
 
Join Date: Jan 2005
Posts: 395
Likes: 0
Received 0 Likes on 0 Posts
Default

Dell,

This was done AT A PORSCHE dealer. I will be asking some pointed questions when they open....
Old 08-02-2005, 12:40 PM
  #4  
LVDell
Nordschleife Master
 
LVDell's Avatar
 
Join Date: Oct 2003
Location: Tobacco Road, NC
Posts: 5,225
Likes: 0
Received 28 Likes on 23 Posts
Default

Ruh Roh! I would be flippin hot at the dealer right about now!!! The strange thing here in Vegas is that even though they have this company out here do their cars (and add it to the sales invoice) is that they send the cars to the company's shop and will NOT allow them to do the install at the dealer......can sombody say liability.

Yup, if I were you I would be having a nice morning chat with the dealer.
Old 08-02-2005, 12:57 PM
  #5  
c4bliss
Racer
Thread Starter
 
c4bliss's Avatar
 
Join Date: Jan 2005
Posts: 395
Likes: 0
Received 0 Likes on 0 Posts
Default

Yes, i am watching the clock now.... must remain calm, must remain calm......
Old 08-02-2005, 01:00 PM
  #6  
LVDell
Nordschleife Master
 
LVDell's Avatar
 
Join Date: Oct 2003
Location: Tobacco Road, NC
Posts: 5,225
Likes: 0
Received 28 Likes on 23 Posts
Default

deep breaths.....
Old 08-02-2005, 01:06 PM
  #7  
wross996tt
Race Car
 
wross996tt's Avatar
 
Join Date: Feb 2005
Posts: 4,855
Received 83 Likes on 62 Posts
Default

I would throw a CEL! That is BS. They should have it removed and repainted.
Old 08-02-2005, 11:41 PM
  #8  
Res Ips
Rennlist Member
 
Res Ips's Avatar
 
Join Date: Dec 2004
Location: PNW
Posts: 1,241
Received 71 Likes on 49 Posts
Default

Originally Posted by c4bliss
Ok, question: I have clear armor on my car. It was just applied. The old was removed due to a very poor install, many fingerprints and stretch marks ect.

So i just get my car back tonight. While looking it over in my garage, i notice many many scratches and ect, from what appears to be the removal of the old armor. The new armor was installed on top of the scratches so i cant get to them to rub them out.

Also, while looking at the front bumper, it appears that they split the armor horizontally across the bumber right below the bumper plugs, from fender to fender. Isn't this supposed to be a one piece install? Not split? It looks like they cut the old with a razor and and matched the new on to it. Is this normal? I am gonna reserve calling up the installer until i get it washed and see what it looks like.
What's "clear armor"?
Old 08-02-2005, 11:57 PM
  #9  
LVDell
Nordschleife Master
 
LVDell's Avatar
 
Join Date: Oct 2003
Location: Tobacco Road, NC
Posts: 5,225
Likes: 0
Received 28 Likes on 23 Posts
Default

Oh Jim, go have a martini and leave the poor guy alone
Old 08-03-2005, 12:08 AM
  #10  
neil.schneider
Drifting
 
neil.schneider's Avatar
 
Join Date: Oct 2004
Location: New Jersey(outside Phila)
Posts: 2,191
Received 431 Likes on 281 Posts
Default

Clear armor is a clear plastic coating put on the car to protest it from rock chips. Kinda like window tint without the tint.
Old 08-03-2005, 12:23 AM
  #11  
SteveFromMN
Pro
 
SteveFromMN's Avatar
 
Join Date: Jul 2004
Location: Minnesota
Posts: 677
Likes: 0
Received 3 Likes on 2 Posts
Default

Bad stuff I told you guys not to do it but do you listen? Noooooooooooooo
Old 08-03-2005, 02:13 AM
  #12  
Premier
Addict
Rennlist
Site Sponsor

 
Premier's Avatar
 
Join Date: Dec 2004
Location: San Francisco Bay
Posts: 1,569
Received 85 Likes on 48 Posts
Default

Sounds like Clear Armor installed it at the dealer for you. If you're interested in getting it done properly, please don't hesitate to give us a call.
__________________
PREMIER PROTECTIVE FILMS
ClearGuard PPF Specialists, Spectra PhotoSync IRD & CeraLuxe IRD, Authorized Modesta and Nanolex Dealer
www.facebook.com/premierprotectivefilms

B: 510-623-1308
sales@premiermobilegroup.com

See Our Projects! http://www.facebook.com/premierprotectivefilms

CLEAR BRA CLEANER -TRACK MARKS ON CLEAR BRA - PF1 TTR!
http://www.premiermobilegroup.com/pf1_products.shtml



Old 08-03-2005, 12:36 PM
  #13  
Res Ips
Rennlist Member
 
Res Ips's Avatar
 
Join Date: Dec 2004
Location: PNW
Posts: 1,241
Received 71 Likes on 49 Posts
Default

Originally Posted by LVDell
Oh Jim, go have a martini and leave the poor guy alone
Old 08-03-2005, 12:38 PM
  #14  
Res Ips
Rennlist Member
 
Res Ips's Avatar
 
Join Date: Dec 2004
Location: PNW
Posts: 1,241
Received 71 Likes on 49 Posts
Default

Originally Posted by neil.schneider
Clear armor is a clear plastic coating put on the car to protest it from rock chips. Kinda like window tint without the tint.
Sort of like a car condom that you can see thru?
Old 08-03-2005, 02:48 PM
  #15  
ventoGT
Three Wheelin'
 
ventoGT's Avatar
 
Join Date: Oct 2004
Location: South Shore, MA
Posts: 1,416
Received 0 Likes on 0 Posts
Default

Jim--nice analogy. It is usually just applied to the front bumper, first half of the hood, mirrors, and the rear haunches [if your car has them]. not applied to the entire car.


Quick Reply: Clear Armor question, help....



All times are GMT -3. The time now is 02:34 AM.