Stripping wiring harness feeding dome light & sunshades
#1
Rennlist Member
Thread Starter
Stripping wiring harness feeding dome light & sunshades
Hello Everyone,
Looking for guidance...
I own a stripped 996 for track only use.
Currently tidying up some of the residual wiring.
There is a small harness that comes up the driver side A-pillar that runs across the top of the windshield feeding the dome lights and the sunshades I believe.
Would like to know; Does this run of wires have a CONNECTOR at its source or do I need to cut it and terminate each wire independently?
Looking for guidance...
I own a stripped 996 for track only use.
Currently tidying up some of the residual wiring.
There is a small harness that comes up the driver side A-pillar that runs across the top of the windshield feeding the dome lights and the sunshades I believe.
Would like to know; Does this run of wires have a CONNECTOR at its source or do I need to cut it and terminate each wire independently?