Ride Height with PSS-9
11-27-2005, 10:58 AM
#18
Addict
Lifetime Rennlist
Member
Lifetime Rennlist
Member
Join Date: Jun 2001
Location: Australia. >>> Now in Gibraltar
Posts: 1,398
Likes: 0
Received 2 Likes
on
2 Posts
Originally Posted by KRA993tt
.... I demonstrated the ability to break Pss9's with the car too low 
......
......
Do tell !!!
11-30-2005, 02:22 PM
#19
Addict
Rennlist Member
Rennlist Member
Join Date: Apr 2003
Location: NC
Posts: 868
Likes: 0
Received 0 Likes
on
0 Posts
Sorry for the delay in responding I am out of town. I installed camber plates on my car that was very low. I think the stock shock mounts had enough cushion in them to mask the geometry problem of lowering the car too much. I am not a mechanic but as soon as the camber plates went on I snapped the upper shaft of the right rear shock right off at the weld. The first one I assumed was a defective part. So I installed a second one and took two runs at VIR and broke the right rear again exactly the same way. My car was about 20mm below RS spec front and rear. After some consultation with my local shop and Steve W. we raised the car to RS spec. I have since run Watkins Glen(2 days) and VIR(3 days) with no furhter problems. Just the bills. 
