head temp sensor replace
Thread Starter
Drifting
Joined: Apr 2010
Posts: 2,288
Likes: 28
From: Plano Texas
head temp sensor replace
ok.. i got the old one out without issue and finally got the new.
the only problem is that I can't get the threads to take. the wire coming off the sensor hits something and will not allow it to turn without getting off the threads.
are there any secrets to getting this @#$%^#@ thing in?
the only problem is that I can't get the threads to take. the wire coming off the sensor hits something and will not allow it to turn without getting off the threads.
are there any secrets to getting this @#$%^#@ thing in?
Rennlist Member
Joined: Jul 2002
Posts: 16,557
Likes: 94
From: Bend, OR
Is this the same as the 3.2's...where it goes in at an angle on the front of the #3 head? If so, I took a long socket and cut a long slot out almost the entire length to clear the wire and used it to screw it in, and tighten. I've not gotten this far in 993 knowledge yet, so maybe I'm talking apple to oranges.
