axl911

Hi all,

I am taking my DachX sport cat off the car for other mods. The cat is in good shape but I have to grind down one of the weld to separate the left side output tube to make it fit perfectly.

You can either put a clamp on it like I did or just easily weld it back up.

I'll take $900 + shipping for it. Will post pics later.

This is for a 95 car with Bischoff exhaust flange.

thanks,
anthony

axl911

Here are pics. As stated before, the cat-to-heat exchanger sides fit perfectly. The cat-to-right muffler fit perfectly. The cat-to-left muffler was misaligned.

Instead of cut and reweld, I had the weld grind down to separate the tube, fitted it to the car, and clamped it back up. I could have weld it back up, but this affords more adjustability. You can weld it up if you want.

My car which I had this on has stock exhaust and mufflers. So it will fit yours too. This cat is still in very good shape, no scratches or gouges.

axl911

See how the muffler end piece slips on and off. As said before, you can fit it. Then decide if you want to just clamp it or run a weld.

Clamp is included.