Glove box door
Thread Starter
Addict
Rennlist Member
Rennlist Member
Joined: May 2002
Posts: 1,281
Likes: 2
From: Canada
Glove box door
I removed my glove box and door to ease the installation of my CDR-220 with iPod connector. All went well but now that I reinstalled the box I can't get the right door arm to hook into anything in the slot.
I did search engine and could not find specific answers.
Was I supposed to attach the door before putting in the 4 screw that hold the box in place?
Do I screw in the bottom 3 screws and then push the arms into their slots?
Help.
I did search engine and could not find specific answers.
Was I supposed to attach the door before putting in the 4 screw that hold the box in place?
Do I screw in the bottom 3 screws and then push the arms into their slots?
Help.
Rennlist Member
Joined: Oct 2004
Posts: 355
Likes: 2
From: Voorhees, NJ
I just had my glovebox out recently while hardwiring my V1. I followed the procedure here:
https://rennlist.com/forums/993-forum/323211-diy-the-definitive-glovebox-door-latch-rattle-repair.html
I don't recall having a problem getting the right side arm back in (the left side was tricky though). But I do recall that I secured the arms before tightening any of the screws.
Good luck!
- Dave
https://rennlist.com/forums/993-forum/323211-diy-the-definitive-glovebox-door-latch-rattle-repair.html
I don't recall having a problem getting the right side arm back in (the left side was tricky though). But I do recall that I secured the arms before tightening any of the screws.
Good luck!
- Dave
