Thanks Coleman-Check Valve DIY success
#1
Rennlist Member
Thread Starter
Thanks Coleman-Check Valve DIY success
Another great Rennlist story. After searching for a 1" crow, I finally gave up and asked Coleman if I could take him up on the offer of borrowing his tool. Coleman was gracious enough to send the item Priority mail the next day. Thank you!
I changed the check valve last night. It's a very easy DIY for those considering the job. Total time took about 45 minutes, and most of that was trying to find the clip to the MAF I dropped. Argh.
The top of the valve had actually rusted off inside the rubber hose, and the filter was FULL of crap. (95 with 80K miles, and I doubt this has ever been changed). I took my son for a quick Father's Day ride today. Not sure if it's just mental, but the car seemed to run much better. I have the LWF, and the rpm's didn't walk at all. Again, could be just in my mind, but....
Now to install the HID kit with Chris' custom mounts....
I changed the check valve last night. It's a very easy DIY for those considering the job. Total time took about 45 minutes, and most of that was trying to find the clip to the MAF I dropped. Argh.
The top of the valve had actually rusted off inside the rubber hose, and the filter was FULL of crap. (95 with 80K miles, and I doubt this has ever been changed). I took my son for a quick Father's Day ride today. Not sure if it's just mental, but the car seemed to run much better. I have the LWF, and the rpm's didn't walk at all. Again, could be just in my mind, but....
Now to install the HID kit with Chris' custom mounts....