Techart rear wing/Deck lid shock question
08-13-2001, 11:36 PM
#1
Three Wheelin'
Thread Starter
Techart rear wing/Deck lid shock question
Does anyone have a Techart rear wing II?
The damm deck lid will not stay up! I have taken off both of the deck lid shocks, part #993.512.321.00 Both of the shocks seem to be working as it takes quite a bit of pressure to compress each shock. Is there something else that can be done to keep the deck lid up?
Thanks in advance,
The damm deck lid will not stay up! I have taken off both of the deck lid shocks, part #993.512.321.00 Both of the shocks seem to be working as it takes quite a bit of pressure to compress each shock. Is there something else that can be done to keep the deck lid up?
Thanks in advance,
08-13-2001, 11:42 PM
#2
Drifting
Join Date: May 2001
Location: Villanova, PA
Posts: 2,331
Likes: 0
Received 0 Likes
on
0 Posts
Eric,
I purchased some new shocks from Performance that were 'heavy duty' ones. I still have the factory spoiler, but when I pull the trunk release lever, the lid pops up on its own. I am sure they would be strong enough to support your aftermarket spoiler with no problem. I think that is what the 'heavy duty' ones are made for.
E. J.
I purchased some new shocks from Performance that were 'heavy duty' ones. I still have the factory spoiler, but when I pull the trunk release lever, the lid pops up on its own. I am sure they would be strong enough to support your aftermarket spoiler with no problem. I think that is what the 'heavy duty' ones are made for.
E. J.
08-14-2001, 12:47 AM
#4
Drifting
Join Date: May 2001
Location: Villanova, PA
Posts: 2,331
Likes: 0
Received 0 Likes
on
0 Posts
I am not sure, it was a while ago. I do remember that they had the words 'heavy duty' in the catalog description. Just tried to access their website, but I couldn't. Sorry.
