Is the 993 C2S knob weighted like the Tequipment knob?
#271
Former Vendor
I should have some starter pics of the handbrakes next week, they are still a good few weeks away from completion though!
We will list them as a set in the future!
We will list them as a set in the future!
#274
I ordered the shift **** from Type911uk last year and recently I feel the aluminum part is getting a little loose. Does anyone know if there are tricks for me to open the top shift pattern plate without scratching the **** to tighten the screws? Is the plate glued in?
Any help appreciated! Thanks.
Andy
Any help appreciated! Thanks.
Andy
Last edited by akrca4; 07-09-2023 at 07:21 PM.
#276
Rennlist Member
I'm also experiencing looseness in the **** - the top gear pattern plate was loose, and now whole **** is pretty loose, with about 2mm lateral movement. @Type911uk I'd be interested in one of these repair kits.
#277
I ordered the shift **** from Type911uk last year and recently I feel the aluminum part is getting a little loose. Does anyone know if there are tricks for me to open the top shift pattern plate without scratching the **** to tighten the screws? Is the plate glued in?
Any help appreciated! Thanks.
Andy
Any help appreciated! Thanks.
Andy
I used the long torx key I think was T-20 from Harbor Freight: https://www.harborfreight.com/6-piec...set-42926.html to pop off the top steel plate from the bottom hole. Hope this helps!
Andy
Last edited by akrca4; 08-21-2023 at 09:18 PM.
#278
Pro
Is a repair kit still needed or just the heat gun and pop the cap off?
#279
Rennlist Member
If Andy resolved the loose top by tightening the 2 screws as per his post I would try that. All new ***** have now been modified so this shouldnt be a problem anymore
The following users liked this post:
Paolo1 (08-31-2023)
#281
Pro
Love the shiftknob. Thanks!
#282