Possible to replace the bushing on the rears of a PSS10
#1
Possible to replace the bushing on the rears of a PSS10
Somehow the rear lower bushings of one of my rear shocks on the set of PSS10s has cracked.
is it possible to just replace the bushing? I know technically it is possible but does anyone know where to source the actual bushing?
thanks
is it possible to just replace the bushing? I know technically it is possible but does anyone know where to source the actual bushing?
thanks
#3
Rennlist Member
Yes. I did it with my pss9s. Similar to the rear control arms, you can easily remove and replace them.
I called Bilstein US in Poway and got the part number from them. It was
E4-GV2-Z010A00
I had to special order them from FVD in Germany for 30 EUR each since no one could order them for me here in the US.
I called Bilstein US in Poway and got the part number from them. It was
E4-GV2-Z010A00
I had to special order them from FVD in Germany for 30 EUR each since no one could order them for me here in the US.
Last edited by samurai_k; 07-21-2020 at 05:19 PM.
The following users liked this post:
paulkromz (07-21-2020)
#5
Rennlist Member
Yea. I sent an email. There is a woman named Rhonda who processed all of my orders from Germany.
I am not sure the pss10 uses the same bushing as the pss9 so I would check Bilstein US to confirm. I sent an email to their Poway location and they were quite responsive.
I am not sure the pss10 uses the same bushing as the pss9 so I would check Bilstein US to confirm. I sent an email to their Poway location and they were quite responsive.
#6
fantastic. I will try that thank you very much.