When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
how much did you lower it? Im about to have the KW installed on my GTS.
When the shop did the install I had them adjust a few times to get it to the height that I desired. Unfortunately I don't know how much it was lowered by. I wish I measure prior to the install.
When the shop did the install I had them adjust a few times to get it to the height that I desired. Unfortunately I don't know how much it was lowered by. I wish I measure prior to the install.
If you have a tape measure (and any interest) you can measure from the ground to the wheel arch acme. Front and back will be different measurements. Should be same left to right. Then we could compare to stock.
If you have a tape measure (and any interest) you can measure from the ground to the wheel arch acme. Front and back will be different measurements. Should be same left to right. Then we could compare to stock.
Sure, if anyone is interested in the measurements I did a quick check this morning. My car is sitting at approximately 27" in the front and approximately 28" 1/16 in the rear. Probably no where near exact but gets you an idea of what the numbers looks like. Hope that helps.
Sure, if anyone is interested in the measurements I did a quick check this morning. My car is sitting at approximately 27" in the front and approximately 28" 1/16 in the rear. Probably no where near exact but gets you an idea of what the numbers looks like. Hope that helps.
Looking good 👍 Any rubbing at all with this fitment and ride height?
Looking good 👍 Any rubbing at all with this fitment and ride height?
Thank you! I am really happy with how it all came together.
As mentioned in an earlier post... no rubbing for the most part. I have had this setup for almost a year now and only heard a slight rub a handful of times. The rare few time I have heard it, I felt like it was very insignificant.
Has anyone else come across this issue with their 992.
The pictures are of the windshield cowling sitting away from the windshield.
‘These are all RH drive cars here in Australia and the issue is always on the LH side which is the passenger side for us here.
It seems to be an assembly issue from the factory where they have pushed down on the rubber molding to clip in the plastic cowling and bent the molding away from the windshield.
The pictures are of a 992 RS ,992 GT3 ,992 GTS and my 992 Touring.
The dealer had three other brand new 992s all with the same issue.
Has anyone else experienced this on their car?