992 RS Aero Suspension Arms
#1
Rennlist Member
Thread Starter
992 RS Aero Suspension Arms
Looks like the leading edge of top and lower arm plus the tie rod are aero shaped. Hard to imagine they are responsible for 40 pounds of additional down force. Must be a lot of turbulence they clean up.
Also is the the upper brake duct present in the GT3?
Starting at 9:40 for the front wheel well over view.
Also is the the upper brake duct present in the GT3?
Starting at 9:40 for the front wheel well over view.
Last edited by Wind911; 10-07-2022 at 02:39 AM.
The following users liked this post:
Arnoux (10-17-2022)
#2
Addict
Rennlist Member
Rennlist Member
Thanks for posting - pretty sure upper ducts are RS-specific (GT3 ones are on lower side, iirc)
The following 4 users liked this post by boyko23:
#5
Rennlist Member
Thread Starter
Looks like Porsche removed the air deflectors on the control arm and inside of wheel well and install this large upper scoop to further clean up the air flow.
The following users liked this post:
GrantG (10-07-2022)
#6
Pure sex.....my hat is off to the engineers.
The following users liked this post:
catdog2 (10-18-2022)
Trending Topics
#8
Rennlist Member
Thread Starter
GT3 vs GT3 RS
#10
I would expect that you need flow to produce downforce, and they have specifically diverted air away from the wheel well on the GT3 - vs. through it on the RS.
The following users liked this post:
GrantG (10-16-2022)
#11
Rennlist Member
#12
Addict
Rennlist Member
Rennlist Member
Last edited by GrantG; 10-16-2022 at 03:07 PM.
#13
GT3 player par excellence
Lifetime Rennlist
Member
Lifetime Rennlist
Member
whoa that is sexy....
I need the car.
I need the car.
#14
Rennlist Member
Even if the airflow through the GT3 wheel well was adequate to produce additional front downforce, it would put things out of balance with the rear wing. When I was at Manthey, they don’t even recommend full stock downforce in front with full rear wing (they recommended 3/4 front downforce setting to go with 4/4 rear wing). So adding even more front downforce with these aero wishbones would require an aftermarket rear wing to put the car in balance (otherwise the rear end is going to be moving around at very high speed).
Id like the RS front suspension pieces, the Manthey rear wing and aerodisc wheels for my GT3