Sorry for bumping an old thread.

i have the sportdesign / GTS bumper & i was trying to install the middle grill (over the long black plastic since I don’t have the third radiator) but I can’t figure where the 2 bottom clips should slip into ?

Looks like it needs to be shaved to fit in the openings, then use 2 screws.

The Zunsport video shows the person using the screwdriver to clip them but doesn’t show the placement of the clips.

Here are the pics of the sides installed. Or should I not install the centre grill at all ?


https://cimg1.ibsrv.net/gimg/rennlis...29378ed36.jpeg
https://cimg8.ibsrv.net/gimg/rennlis...cfa08e263.jpeg
https://cimg4.ibsrv.net/gimg/rennlis...7e8557cc1.jpeg

On the 991.2 GTS I had I just slid it into the opening (no clips), held it in place, and inserted the screws, which was enough to hold it in place. Personally, I hated the look of that plain, black piece so the mesh was perfect, and it matched the other pieces!

https://cimg5.ibsrv.net/gimg/rennlis...37aac7f365.jpg

hey bro what kind of paint would you recommend for doing this?

I just used a Flat Black rattle can, paint & primer in one such as by Krylon.

Roger that - thanks for confirming! Appreciated.

Needless to say, I taped off the area around them very well to avoid overspray using newspaper and painter's tape.

hello is there a part # for 991.1 cab 2013?
with park sensors

Do they offer these for the 991.2 Carrera T? I looked on their site but I don’t see a listing.

It's the same as the Carrera S. Model number ZPR82016B linked here: https://www.zunsport.com/en/product/...roduct_id=5964

My T's radiators are beaten to hell after fewer than 15K miles, though some of them are track miles. I have a set of CSF radiators en route and will be installing the Zunnsport before they go in. I wish I had installed these form the get go.

I put them on both my 2014 C2 Cab and my 2019 GTS Cab. In both cases the final result was excellent but FWIW I found each installation presented challenges. Parts or the tabs to secure them required some re-engineering.