When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Since I've been distributing this manual for the past few years to all comers, I would like everyone to know that I do custom automotive paintings/design sketches. PM me for deets if interested.
Is it possible to get the workshop manual? I made a few DIYs for the 958 Cayenne over the years. I'll start making them for the 991 GT3 too as I go through the maintenance cycle.
It would be awesome if I could get a copy of 991 GT3RS service manual. I have the 991 Carerra manual, but it's not comprehensive enough for GT3RS, especially engine assembly.
Would be much appreciated. Thanks.
The factory 991 Carrera manual actually also covers GT3, engine mechanical to body panels. You can actually get by using this workshop manual. However, one of the important information not included, is the torque spec for Porsche's GT3RS updated conrod bolt. The infamous design blunder that caused the recall of all 991 GT3RS on it's release, as the bolt would loosen and self destruct the engine. That's because Porsche didn't foresee this screw up when the workshop manual was released. The M10 x 1.25mm conrod bolt was replaced by a M10 x 1.00mm bolt, to secure the conrod more tightly to better withstand the 9000rpm rev limit. The 991 Carrera workshop manual in PDF can be found in Rennlist forum, else you can PM me for a copy.
The factory 991 Carrera manual actually also covers GT3, engine mechanical to body panels. You can actually get by using this workshop manual. However, one of the important information not included, is the torque spec for Porsche's GT3RS updated conrod bolt. The infamous design blunder that caused the recall of all 991 GT3RS on it's release, as the bolt would loosen and self destruct the engine. That's because Porsche didn't foresee this screw up when the workshop manual was released. The M10 x 1.25mm conrod bolt was replaced by a M10 x 1.00mm bolt, to secure the conrod more tightly to better withstand the 9000rpm rev limit. The 991 Carrera workshop manual in PDF can be found in Rennlist forum, else you can PM me for a copy.
I would like the manual but I cant send you a PM as it says you dont have enough posts in the forum to receive a PM.