RS side skirts on a GT3 - done!
#16
#19
#20
As far as fitment, the curvature towards the rear of the side skirts doesn’t match up to the body line 100%. It’s one of those things you won’t notice unless you know it’s there. I tried taking closeup shots so you can see but even in pics it’s hard to tell
#24
#25
#28
Yes I was thinking along that line. RS wing, RS fenders, RS bumper, RS hood, hell even RS roof... oh wait ����
Had to take the decals off for paint correction. They'll be back on
��
I've had a few PMs with regards to part numbers and source. Peter at Suncoast helped me with these
991.504.795.82 Driver Side
991.504.796.82 Passenger Side
About $450 shipped. It took about 2 months for them to come from Germany. With that in mind, if there is enough interest, someone should organize a group buy to save shipping and perhaps get a discount. However, before you guys commit, please understand that the fitment isn't 100%. I've tried taking photos from different angles but it's hard to show on photos being my car is black and the part is also black. Perhaps I posted this a little premature as I'm still thinking of ways to make it fit perfectly... but I'm no expert. My temporary solution for it is putting black electrical tape right on top of the side skirts at the exposed area (between the skirt and the body line) so that it's a clean finish there. You can see the difference between the body line and the line of the side skirt here. At the widest spot, the difference is about 3mm
Original pic
��
I've had a few PMs with regards to part numbers and source. Peter at Suncoast helped me with these
991.504.795.82 Driver Side
991.504.796.82 Passenger Side
About $450 shipped. It took about 2 months for them to come from Germany. With that in mind, if there is enough interest, someone should organize a group buy to save shipping and perhaps get a discount. However, before you guys commit, please understand that the fitment isn't 100%. I've tried taking photos from different angles but it's hard to show on photos being my car is black and the part is also black. Perhaps I posted this a little premature as I'm still thinking of ways to make it fit perfectly... but I'm no expert. My temporary solution for it is putting black electrical tape right on top of the side skirts at the exposed area (between the skirt and the body line) so that it's a clean finish there. You can see the difference between the body line and the line of the side skirt here. At the widest spot, the difference is about 3mm
Original pic
Last edited by SocalTouring; 02-25-2019 at 09:12 PM.