When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
So I’m refitting my rear bumper after the car has had a complete strip repaint. There’s a groove for the rubber strip to sit in which I intend to place the seal in before I tighten the top fixing clamps that secures the bumper. So what is puzzling me is why the genuine seal has one end tapered and also a steel pin comes with it. Any help and fitting tips greatly appreciated.
It's been a long time since I messed with those but I think the pin slide into the end of the seal and that allows you to bend the end of the seal around an edge to hide it or secure it.
Last edited by Boeing 717; 06-27-2020 at 10:56 AM.