Porsche special tool 9290
#2
Racer
![Default](https://rennlist.com/forums/images/icons/icon1.gif)
I made my own by buying the correct size bolt and turning the end down.
I am sure there is a thread on the forum giving the dimensions. Probably did not save much money it was quicker and easier than buying the part
I am sure there is a thread on the forum giving the dimensions. Probably did not save much money it was quicker and easier than buying the part
#3
![Default](https://rennlist.com/forums/images/icons/icon1.gif)
Here is a thread where JasonAndreas gives the dimensions
https://rennlist.com/forums/964-foru...-9285-1-a.html
https://rennlist.com/forums/964-foru...-9285-1-a.html
Last edited by machisono; 06-25-2014 at 02:47 AM. Reason: too fast for my own good
#5
Drifting
Thread Starter
#6
Technical Guru
Rennlist Member
Rennlist Member
#7
Drifting
Thread Starter
Trending Topics
#10
Three Wheelin'
![Default](https://rennlist.com/forums/images/icons/icon1.gif)
Guilty of hoarding Rob's giant wrench and the special pulley bolt. I should be finished up with them sometime next week and am happy to mail them out, with Rob's approval. I will say that it's an extremely satisfying tool to use!
#15
Burning Brakes
![Default](https://rennlist.com/forums/images/icons/icon1.gif)
Hey there.. i will send a PM but for the sake of posting publicly, I'm removing the TPC supercharger kit from my car and need the 9290 tool at least to hold the crank pulley. if I need the bolt too to remove the TPC pulley from the 993 crank, that's great, if I can borrow that too
I own the 9548 tool for reinstalling my 993 crank pulley... just dont have access at this time to the 964 tool that my buddy (who works at the Dealership) loaned me last time. He's out of state in Porsche school and I'd love to get it done next week. Thanks!
![Smilie](https://rennlist.com/forums/images/smilies/smile.gif)