Start of a Winter Project
02-13-2010, 06:03 PM
#31
Rennlist Member
Thread Starter
RS Mount Issue
I installed my RS Mounts and the Right hand side mount bolt gets ****-eyed. I loosened the Right handside and tried to put it back up and still gets misaligned looking. Any advice would be appreciated.
Here is a pic of the Right side. You can see that the Big washere is not evenly seated on the mount so you can see the black rubber part of the mount.
This is the Left side mount. The big Washers is seated evenly on the mount.
Here is a pic of the Right side. You can see that the Big washere is not evenly seated on the mount so you can see the black rubber part of the mount.
This is the Left side mount. The big Washers is seated evenly on the mount.
02-14-2010, 09:49 AM
#33
Seared
Rennlist Member
Rennlist Member
Ceby,
Excellent write-up. I plan on buying the Rennline brace as well and then welding it at home.
The RS mounts are very nice - super simple, stout, and very little increase in transmitted engine vibrations. Here's a pic of mine - installed two years ago:
Andreas
Excellent write-up. I plan on buying the Rennline brace as well and then welding it at home.
The RS mounts are very nice - super simple, stout, and very little increase in transmitted engine vibrations. Here's a pic of mine - installed two years ago:
Andreas
