Scantool and Durametric questions - what are these parameters?
#1
Rennlist Member
Thread Starter
Scantool and Durametric questions - what are these parameters?
I've been playing with the Scantool and a Durametric scanner, but there are a few entries that I can't figure out. Anyone know these?
Scantool parameter / My Reading
---------------------- / --------------
tiplgTmChg = 5 degrees at idle
HO2S = 213 MV
Base inj. time = 0.82 ms
Base inj. 8-bit LOAD = 1.6 ms
Durametric parameter / My Reading
------------------------ / --------------
TRA = 0
FRA = 1
Oxygen sensing 0.9
Scantool parameter / My Reading
---------------------- / --------------
tiplgTmChg = 5 degrees at idle
HO2S = 213 MV
Base inj. time = 0.82 ms
Base inj. 8-bit LOAD = 1.6 ms
Durametric parameter / My Reading
------------------------ / --------------
TRA = 0
FRA = 1
Oxygen sensing 0.9