I'm trying to get the pressure plate out of my G50,

It looks like the pivot pin for the throw out bearing actuator has to come out...

I see that it is threaded, and I've tried to pull it, it just don't move!

Any tricks?

 

Are you trying to separate the engine and the transmission or are you trying to separate the release bearing and the pressure plate?

If you are trying to separate the tranny from the engine and the "operating shaft" is not coming out when you pull on the bolt that you've threaded into it, the best way to get it out would be to take a 15mm or 17mm socket, a long bolt, a nut and several washers and use them to fashion a puller. If you need pictures let me know.

 

I just thread a bolt into it and then use a pair of needle nose pliers as a fulcrum.

 

The transaxle is already separated.

I'll try it again! seems to be stuck...