964 cab and kid seats (big kids)
#16
Burgled
Rennlist Member
Rennlist Member
Here is the picture of my backseat. Not real good as once again the floods came this afternoon and i couldnt take the top down. I noticed my seats look different then the previous pictures above. Hope this helps
#17
Burgled
Rennlist Member
Rennlist Member
Last edited by jimq; 06-15-2004 at 09:29 PM.
#19
RL Community Team
Rennlist Member
Rennlist Member
Thanks Jim, DMA and Howard for those great pictures - I appreciate it. I've never been able to inspect the rear seats of a cabrio before.
It appears you would have to have the rear seat backs down before putting the cabrio top down, correct?? When my rear window is unzipped, it lays right where those seat backs are, and the overhead crossmember folds right where the seats are too - how does that work?
It would seem you could not have the seats up with the top down. Can you?!
It appears you would have to have the rear seat backs down before putting the cabrio top down, correct?? When my rear window is unzipped, it lays right where those seat backs are, and the overhead crossmember folds right where the seats are too - how does that work?
It would seem you could not have the seats up with the top down. Can you?!
#20
Burgled
Rennlist Member
Rennlist Member
Nope. You can leave them up or down. Matter of fact I tuck the top cover in behind the seat backs to keep it from flapping in the wind.
#21
Addict
Lifetime Rennlist
Member
Lifetime Rennlist
Member
Thread Starter
Hey guys
Didn't buy the 964, (got a 911 carrera instead) but I wanted to give you some of the good info I found.
EZ-ON products has a converter that allows you to make your two point belt into a 4 point. You need to find a place for the tether, but that's just a hole, a bolt and some reinforcements.
http://www.ezonpro.com/uny/index.html
Here it is for sale, ebay store:
http://cgi.ebay.com/ws/eBayISAPI.dll...tem=2397693978
Didn't buy the 964, (got a 911 carrera instead) but I wanted to give you some of the good info I found.
EZ-ON products has a converter that allows you to make your two point belt into a 4 point. You need to find a place for the tether, but that's just a hole, a bolt and some reinforcements.
http://www.ezonpro.com/uny/index.html
Here it is for sale, ebay store:
http://cgi.ebay.com/ws/eBayISAPI.dll...tem=2397693978